Dell UPS 1920R - Manual (Page 35)

35
Installation |
Table 2. Power Cord Ratings (continued)
Dell UPS Model and Voltage Supplied Cord Set Country Rating Power Cord
2700W 230V
CEE 7/7 Schuko to C19 16A Europe (Schuko) Yes
BS 1363 to C19 13A United Kingdom (New) Yes
GB2009.1 to C19 16A China Yes
C19 to C20 Jumper 16A Europe/Australia Yes
C19 to C20 Jumper 16A China Yes
BS 546 to C19 15A United Kingdom(Old) Optional
TI16S3 to C19 16A Thailand Optional
AS 3112 to C19 15A Australia Optional
IRAM2073 to C19 16A Argentina Optional
CEI 23-50 to C19 16A Italy Optional
KSC8305 to C19 15A South Korea Optional
IS 1293 to C19 16A India Optional
NBR 14136 to C19 16A Brazil Optional
C19 to C20 Jumper 16A North America Optional
L6-20P to C19 15A North America Optional
4
For models with a detachable power cord. Plug the detachable UPS power cord into the input
connector on the UPS rear panel.
5 Plug the UPS power cord into a power outlet.
The UPS front panel display illuminates. The Dell startup screen changes to the UPS status
summary screen. The UPS front panel display shows the flashing Standby icon
.
6 Press the button on the UPS front panel.
After the startup is complete, the status icon changes to the appropriate icon based on the UPS
operating mode (see Table 4 on page 42).
7 On the UPS status summary screen, press the button to check for active alarms or notices.
Resolve any active alarms before continuing. See “Troubleshooting” on page 69.
If there are no active alarms, a “No Active Alarms” message appears.
8 Verify that the Normal icon appears on the UPS status summary screen, indicating that the
UPS is operating normally and any loads are powered (see Table 4 on page 42).
9 If an optional EBM is installed, see “Configuring the UPS for an EBM” on page 54.