Dell XPS M2010 (MXP061, Mid 2006) - Manual (Page 52)

Video Card/Thermal-Cooling Assembly: Dell XPS M2010 Service Manual
file:///C|/Users/santhosh_v.ASIA-PACIFIC/Desktop/Hawke/New%20folder/video.htm[2/21/2014 11:26:22 AM]
1 video card/thermal-cooling
assembly
2 captive screws
(4)
3 system board connector
(JVGA)
NOTE: The video card is integrated with its thermal assembly. Do not remove the heatsink from the video card.
9. Pull the video card/thermal-cooling assembly straight up to disconnect the card from the system board.
Replacing the Video Card/Thermal-Cooling Assembly
1. Align the video card/thermal-cooling assembly over the connector and screw holes on the system board.
2. Press down on the "PUSH HERE" label on the video card/thermal-cooling assembly.
3. Tighten in consecutive order the four captive screws, labeled "1" through "4", on the video card/thermal-cooling
assembly.
4. Connect the video cable to the connector on the video card.
5. Replace the right hard drive (see Replacing a Hard Drive ).
6. Replace the top cover (see Replacing the Top Cover ).
7. Replace the cosmetic covers (see Replacing the Cosmetic Covers ).
NOTICE: To avoid damage to the keyboard, ensure that you attach the keyboard securely before moving the
computer.
8. Firmly attach the keyboard to the computer and close the display (see Closing the Display ).
9. Turn the computer upside down and replace the system battery (see Replacing the System Battery ).