Dell XPS M2010 (MXP061, Mid 2006) - Manual (Page 8)

Memory Module: Dell XPS M2010 Service Manual
file:///C|/Users/santhosh_v.ASIA-PACIFIC/Desktop/Hawke/New%20folder/memory.htm[2/21/2014 11:25:59 AM]
Removing the Memory Module
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory-module
securing clips.
1. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the
module pops up.
2. Remove the module from the connector on the system board.
1 securing clips (2 per connector) 2 memory modules (2) 3 system board connectors (2)
Replacing the Memory Module
NOTICE: Insert memory modules at a 45-degree angle to avoid damaging the connector.
NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message
indicates this failure.
NOTE: To get maximum performance/dual-channel memory bandwidth capability, both memory module connectors
must contain memory modules and the modules must be of the same size and configuration.
1. Align the notch on the edge of the memory module connector with the tab in the connector on the system board, and
slide the module firmly into the connector at a 45-degree angle.
2. Rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.
3. Replace the memory cover. Align the notches in the cover with the tabs on the base, slide the cover toward the front of
the computer, and tighten the captive screw.
NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage
your computer.
4. Replace the system battery (see Replacing the System Battery ).
5. Turn the computer over and open the display (see Opening the Display ).
6. Press the power button to turn the computer on.
As the computer boots, it detects the additional memory and automatically updates the system configuration information.