Dell Latitude E5500 - Manual (Page 23)

1. Align the display hinges with the holes in the base of the computer, then lower the display into place.
2. Replace the two pairs of M2.5 x 8-mm hinge screws on the bottom and top of the computer.
3. Route the display cable and antenna cables beneath the plastic tabs on the palm rest.
4. Slide the antenna cables through the hole in the palm rest and the base of the computer.
5. Connect the display cable to the display cable connector on the system board.
6. Replace the keyboard (see Replacing the Keyboard ).
7. Replace the hinge cover (see Replacing the Hinge Cover ).
8. Close the display and turn the computer over.
9. Replace the bottom of the base assembly (see Replacing the E5500 Bottom of the Base Assembly ).
10. Follow the procedures in After Working on Your Computer .
E5500 Display Bezel
Removing the E5500 Display Bezel
1. Follow the instructions in Before Working on Your Computer .
2. Remove the hinge cover (see Removing the Hinge Cover ).
3. Remove the keyboard (see Removing the Keyboard ).
4. Remove the display assembly (see Removing the E5500 Display Assembly ).
5. Starting at the middle bottom of the display panel, use your fingers to separate the bezel from the top cover, then lift the inside edges to separate the
remainder of the bezel.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTE: This procedure assumes that you have completed the removal procedure first.
NOTICE: Ensure that the antenna cables are properly routed and secured beneath the plastic tabs on the palm rest.
1 antenna cables
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.