Dell ST2010B Flat Panel Monitor - Manual (Page 25)

To connect your monitor to the computer:
1. Turn off your computer and disconnect the power cable.
2. Connect the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer.
3. Turn on your monitor and computer. If your monitor displays an image, installation is complete. If it does not display an image, see Troubleshooting your
monitor .
Attaching the Soundbar
Removing the Base
Back to Contents Page
NOTICE: Do not use with any device other than the Dell Soundbar.
1. Working from the back of the monitor, attach the Soundbar by aligning the two slots with the two tabs along the bottom of the monitor.
2. Slide the Soundbar to the left until it snaps into place.
3. Connect the Soundbar with the DC power connector.
4. Insert the mini stereo plug from the back of the Soundbar into the computer's audio output jack.
NOTE: To prevent scratches on the LCD screen while removing the stand, ensure that the monitor is placed on a soft, clean surface
After placing the monitor panel on soft cloth or cushion, complete the following steps to remove the base.
1. Press the hook to loosen the base from the riser.
2. Detach the base away from the monitor hinge.