Placing documents, P.13.) – Canon IMAGE FORMULA DR-3010C User Manual
Page 18
Chapter 2 Basic Operation
- 13 -
There are two methods for feeding documents, the Page Separation mode and
Bypass mode. Feeding pages continuously from a stack of documents placed in
the feed tray is called the Page Separation mode. Feeding documents one sheet
at a time or feeding documents consisting of multiple pages that are attached, is
called the Bypass mode.
The document feed method can be changed by moving the feed selection lever.
1
Switch the feed selection lever to
(Page Separation).
2
Adjust the document guides to fit the width of the document to be scanned.
3
Fan the pages of the document to be scanned, and then turn the document
so that it is upside down.
CAUTION
When placing documents into the feed tray, take care not to cut your hands on
the edges of the paper.
4
Place the document face down, with the top fed through the scanner first.
IMPORTANT
There is a load limit mark (
) on the document guides. Do not stack
documents higher than this mark (approximately 50 sheets of 20 lb bond (80 g/
m
2
) paper.) Doing so may cause a paper jam.
Feeding in the Page Separation Mode
3. Placing Documents