Tri-Tronics Companion - Manual (Page 10)

TRANSMITTER
Setting the Rocker Switches. The upper rocker switch
on the back of the transmitter is used to set the collar
to produce either continuous (C) or momentary (M)
stimulation. When the upper switch is set to M, the
lower rocker switch can be used to set the length of the
pulse the dog feels. The HI setting is about four times
as long as the LO setting. The dog will feel both as brief
bursts of stimulation, but HI will feel stronger than LO.
Three combinations are possible by setting the
rocker switches.
• Upper rocker on C – pressing the stimulation button
produces continuous stimulation. The HI/LO rocker
switch has no effect. It may be in either position.
• Upper rocker on M and lower rocker on LO –
pressing the stimulation button produces low-level
momentary stimulation.
• Upper rocker on M and lower rocker on HI –
pressing the stimulation button produces higher-level
momentary stimulation.
See the section “Operating the Companion” on
page 12 for information about continuous and
momentary modes.
Another way to control the strength of stimulation is
to change the variable intensity contact point in the
collar. Doing this will change the strength of both the
continuous and the momentary stimulation.
See the section “Contact Points” on page 14 for a
discussion of this feature. Also see pages 16 and 17
for tips on what intensity levels to use for training.
Transmitter Page 8