Tri-Tronics Companion - Manual (Page 12)

COLLAR
On/Off Switch. To activate the collar, press the on/off
switch until you hear a “click.” To turn off the collar,
press this switch again until you hear the “click.”
When the collar is active, the red LED will blink
slowly (once per second).
Collar LED. The LED on the collar has three functions.
First, it tells you when the collar is active. Second, it
tells you what the stimulation is doing. Third, it tells
you when the collar batteries are beginning to get low.
• Light blinks once per second – collar is active.
• Light glows steadily – stimulation is being delivered.
• Light blinks eight times per second – batteries are
getting low.
When the transmitter is set for continuous stimulation
(C), the light will stay on as long as the stimulation
button is held down, or until time-out occurs.
When the transmitter is set for momentary stimulation
(M), the light will stay on very briefly for LO and
slightly longer for HI, no matter how long the
stimulation button is held down.
Note that in the momentary mode, it is normal for the
LED to continue to glow steadily for a few moments
after the button is released.
Collar Page 10