Tri-Tronics Companion - Manual (Page 22)

CARE AND CLEANING
A little care can extend the life of the Companion
and reduce service costs.
Battery Life. Avoid leaving the collar or transmitter
for long periods in very warm areas, such as closed
automobiles in the sun. If you will not be using the
Companion for several months, remove the batteries.
Dirt and Corrosion. Outdoor conditions can be harsh
on the surfaces of the collar. After exposure to brackish,
salt, or alkaline water, wash the collar with clean
drinking water and use a small brush to remove any
foreign materials, particularly around the contact
points, the on/off switch, and the battery compartment
end cap. Do not use acids, alkalis, solvents, or abrasive
tools for cleaning.
Contact Point Tightness. The contact points on the
collar can become loose. Inspect the contact points for
tightness each time you put the collar on your dog.
If the contact points need tightening, use the plastic
tool that comes with the Companion.
Battery Compartment Seal. A good O-ring in the
collar battery cap is very important. If the O-ring
becomes cracked, worn, or missing, water can enter
the battery compartment and cause damage.
Inspect the O-ring for signs of cracking and replace
it if needed. O-rings can be purchased at most
hardware stores.
Whenever you install new batteries in your collar,
make sure that the O-ring is still present, and
that it’s in good condition. Make sure you tighten
the battery compartment end cap to the
recommended position.
Care and Cleaning Page 20