Tri-Tronics Companion - Manual (Page 11)

Applying Stimulation. The gray button on the side
of the transmitter is the stimulation button. Press this
button to make the collar deliver electrical stimulation.
Transmitter LED. This LED will come on when the
stimulation button is pressed. The time that it takes to
turn off will depend on which mode (C or M) you’re in.
In momentary mode (M) in both HI and LO, the LED
will turn off after approximately one-half of a second.
In continuous mode (C), the LED will turn off when the
button is released, or at “time-out” (about ten seconds),
whichever comes first.
If the LED fails to light, or the light emitted is very
dim, it’s time to replace the transmitter battery.
Belt Clip. The Companion is shipped with a belt clip
already attached. Tighten the screw prior to use. To
remove the belt clip, loosen the small screw holding
it in place.
You can slide the strap of the collar through the
transmitter belt clip and buckle it – a convenient
way to keep the transmitter and receiver together.
Page 9 Companion