Recording tv programs, 1 insert a cassette, 2 turn on the tv – Sony SLV-R1000 User Manual
Page 34: To stop recording, To pause the cassette, When the cassette reaches its end
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
Recording TV Programs
Before you begin, check the following points:
• Make sure that the connections have been made correctly
(see pages 6 to 15).
• Check the input mode indicator in the display window of
the VCR.
Press INPUT SELECT so that the LINE indicator
disappears and the TUNER indicator appears in the
display window.
Check that the REC LEVEL control is set to the 0 position.
CAUTION:
Television programs, films, video cassettes and other
materials may be copyrighted. Unauthorized recording
of such materials may be contrary to the provisions of
the copyright laws. Also, use of this recorder with cable
television transmission may require authorization for the
cable television and/or program owner.
Recording TV Programs
You can record in the S-VHS format or the VMS format using an S-VHS tape. Normally you should set the S-VHS ON/OFF switch
to ON. However, if you intend to play back on another VHS format recorder, set the S-VHS ON/OFF switch to OFF. (For details.
1
Insert a cassette.
The VCR turns on automatically (auto power on).
2
Turn on the TV.
If you are using a cable box, turn it on.
3
If your TV is connected to both VHF/UHF OUT and
LINE OUT 1 or 2 on the VCR, select the input for the
VCR.
4
If your TV is connected only to VHF/UHF OUT, set the
TV to the correct channel (CH 3 or CH4), then press
TV/VTR so that the VTR indicator lights up in the
display window.
Skip this step if your VCR is connected to both the
VHF/UHF OUT and LINE OUT 1 or 2.
5
Select the channel to be recorded with CHANNEL
+/— or the channel number buttons and press
ENTER.
6 Select SP or EP with TAPE SPEED (SP/EP).
To select the best recording tape speed, see “Maximum
Recording Time of a Cassette” on page 29.
7
Press the two # REC buttons on the Remote
Commander at the same time, or the • REC button
on the VCR.
The REC indicator lights up on the VCR.
To stop recording:
Press ■ STOP.
To pause the cassette:
Press II PAUSE. To resume recording, press II PAUSE.
When the recording pause mode lasts for approximately 5
minutes, the VCR enters the stop mode.
When the cassette reaches its end:
The cassette rewinds to the beginning and the power
remains on.
34
Basic Operations