Troubleshooting guide, General – Sony CDX-4160 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Troubleshooting guide

The following checklist will help you remedy the problems that you may encounter with your unit

Before going through the checklist below, check the connection and operating procedures.

General

Problem

Cause/Solution

No sound.

• Adjust the volume with

(T).

• Set the fader control to the center position for two-speaker

systems.

The contents of the memory

have been erased.

• The power cord or battery has been disconnected.
• The reset button has been pressed.

—► Store the settings again into the memory.

Indications do not appear in the
display.

Remove the front panel and clean the connectors. See "Cleanin
the connectors" (page 9) for details.

No beep tone.

• An optional power amplifier is connected and you are not

using the built-in amplifier.

• The beep tone is muted (page 8).

CD playback

-

Problem

Cause/Solution

CD cannot be loaded.

• Another CD is already loaded.
• The CD was forcibly inserted upside down.

Play does not begin.

Dusty disc.

CD is automatically ejected.

The ambient temperature is more than 50°C (122°F).

CD will not eject.

Press the ^ button for two seconds.

The operation buttons do not
function.

Press the reset button.

The sound skips due to
vibration.

• The unit is installed at an angle of more than 20°.
• The unit is not installed in a sturdy part of the car.

Radio reception

Problem

Cause/Solution

Preset tuning is not possible.

• Store the correct frequency.
• The broadcast signal is too weak.

Automatic tuning is not

possible.

The broadcast signal is too weak.
—♦ Use manual tuning.

The “ST" indication flashes.

•Tune in the frequency correctly.
• The broadcast signal is too weak.

—• Set to the MONO mode (page 7).

Error displays

The following indications will flash for about five seconds.

Display Cause

Solution

r

n

u

^

CD is dirty

C

^ '

down.

or inserted upside Clean or insert the CD correctly.

p

q q

The CD player cannot be operated Press the reset button or

^ ^ ^ because of some problem.

If the above-mentioned solutions do not help improve the situation, consult your nearest Sony
dealer.

Advertising