Sony CDX-4160 - Manual (Page 7)

3 Press either side of ( seek / ams ) to tune
in the station that you want to store on
the number button.
4
Press the desired number button (QD to
®) for two seconds until "MEM"
appears.
The number button indication appears in
the display.
Note
If you try to store another station on the same number
button, the previously stored sifliion will be erased.
Receiving the memorized
stations
1 Select the desired band (page 6).
2
Press the number button (® to
(6))
momentarily where the desired statiorr is
stored.
If you cannot tune in a preset
station
Press either side of ( seek / ams )
momentarily to search for the station
(automatic tuning).
Scanning stops when the unit receives a
station. Press either side of ( SEEK/AMS)
repeatedly until the desired station is
received.
Note
If the automatic tuning stops too frequently, press
(SENS) momentarily until "LCL" appears in the display
(local seek mode). Only the stations with relatively strong
signals will he tuned in.
Tip
If you know the frequency of the station you want to listen
to, press and hold either side of (
SEEK/AMS ) for two
seconds until the desired frequency appears (manual
tuning).
If FM stereo reception is poor
— Monaural Mode
Press ( SENS) momentarily until "MONO"
appears.
The sound improves, but becomes
monaural ("ST” disappears).
To go back to the normal mode, press again
until "MONO" disappears.
Changing the displayed items
Each time you press (DSPL). the items
alternate between the frequency and time.
Other Functions
Adjusting the sound
characteristics
You can adjust bass, treble, balance and fader
Each source can store the bass and treble levei
independently.
1 Select the item you want to adjust by
pressing ( sel ) repeatedly.
VOL (volume) -► BAS (bass) -► TRE
(treble) -► BALANCE (balance) -► FADE!
(fader)
2 Adjust the selected item by pressing (+)
or O-
Adjust within three seconds after selecting
the item. (After three seconds, the buttons
work as volume control buttons.)
Muting the sound
Press (MUTE).
"MUTE" flashes.
To restore the previous volume level, press
(MUTE) again.
Changing the sound and
beep tone
Enjoying bass and treble even at
low volume — Loudness
(CDX-3160 only)
Bass and treble will be reinforced.
Press (T) while pressing ( sel ).
"LOUD" appears in the display.
To cancel, press these buttons again.
Boosting the bass sound — D-bass
(CDX-4160 only)
You can enjoy clear and powerful bass sound
The D-bass function boosts the low frequency
signal with a sharper curbe than conventional
bass boost.