Inserting a scene – Sony DCR-TRV510 User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Inserting a scene
You can insert a scene in the middle of a recorded tape by setting the start and end
points. The previously recorded frames between these start and end points will be
erased. Use the Remote Commander for this operation.
k [a]
[b]
II
l
(1)
While your camcorder is in the standby mode, keep pressing EDITSEARCH,
and release the button at the insert end point
[bj.
(2)
Press ZERO SET MEMORY. The ZERO SET MEMORY indicator flashes and
the tape counter resets to zero.
(3)
Keep pressing the - © side of EDITSEARCH and release the button at the
insert start point
[a].
(4)
Press START/STOP to start recording. The scene is inserted. Recording stops
automatically at the tape counter zero point. Your camcorder returns to the
standby mode.
EDITSEARCH
Notes
•The zero set memory function works only for tapes recorded in the DigitalS system.
•The picture and the sound may be distorted at the end of the inserted section when it
is played back.
If you re-record on the section which contains a non-recorded section
The zero set memory function may not work correctly.
When START/STOP MODE is set to
±
or5SEC
You cannot use the zero set memory function.
41