Additional settings (option), Degaussing the screen, Adjusting the moire – Sony CPD-G200 User Manual

Page 11: Changing the menu’s position, Locking the controis, To cancel the control lock

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising

Additional settings (OPTION)

You can manually degauss (demagnetize) the monitor, adjust the
moire cancellation level, change the menu position, and lock the

controls.

1 Press the center of the control button.

The main MENU appears on the screen.

2 Move the control button to highlight 3 OPTION and

press the center of the control button again.

The OPTION menu appears on the screen.

3 Move the control button to select the desired

adjustment Item.

Adjust the selected item according to the following

instructions.

Degaussing the screen

The monitor is automatically demagnetized (degaussed) when the

power is turned on.

To manually degauss the monitor, first move the
control button 4/f to select tf (DEGAUSS). Then move
the control button

The screen is degaussed for about 5 seconds. If a second degauss
cycle is needed, allow a minimum interval of 20 minutes for the

best result.

Adjusting the moire*

If elliptical or wavy patterns appear on the screen, adjust the
moire cancellation level.

To adjust the amount of moire cancellation, first move
the control button to select {H- (MOIRE ADJUST).
Then move the control button until the moire
effect is at a minimum.

Changing the menu’s position

Change the menu’s position if it is blocking an image on the

screen.

To change the menu’s on-screen position, first move
the control button 4^/f to select S (OSD H POSITION)
for horizontal adjustment, or (OSD V POSITION) for
vertical adjustment. Then move the control button

to shift the on-screen menu.

Locking the controis

To protect adjustment data by locking the controls, first

move the control button 4^/f to select Om (CONTROL

LOCK). Then move the control button to select ON.

Only the (!) (power) switch, EXIT, and

(CONTROL LOCK)

of the S OPTION menu will operate. If any other items are

selected, the

mark appears on the screen.

To cancel the control lock

Repeat the procedure above and set

(CONTROL LOCK) to OFF.

Moire is a type of natural interference which produces soft, wavy lines
on your screen. It may appear due to interference between the pattern
of the picture on the screen and the phosphor pitch pattern of the
monitor.

Example of moire

□

Advertising