Sony CPD-G200 - Manual (Page 16)

Self-diagnosis function
This monitor is equipped with a self-diagnosis function. If there is
a problem with your monitor or computer, the screen will go
blank and the (!) (power) indicator will either light up green or
flash orange. If the (!) (power) indicator is lit in orange, the
computer is in power saving mode. Try pressing any key on the
keyboard.
J
Specifications
(!) (power) indicator
If the (!) (power) indicator is green
1 Disconnect the video input cable or turn off the
connected computer.
2 Press the (!) (power) button twice to turn the monitor
off and then on.
3 Move the control button ^ for 2 seconds before the
monitor enters power saving mode.
CRT
Viewable image size
Resolution
Maximum
Recommended
Standard image area
Deflection frequency*
AC input voltage/current
Power consumption
Dimensions
Mass
Plug and Play
Supplied accessories
0.24 mm aperture grille pitch (center)
17 inches measured diagonally
90-degree deflection
FD Trinitron
Approx. 327 X 243 mm (w/h)
(12^/8 X 9 Vs inches)
16.0" viewing image
Horizontal: 1600 dots
Vertical: 1200 lines
Horizontal: 1024 dots
Vertical: 768 lines
Approx. 312
X
234 mm (w/h)
(12 '^/8 X 9 */4 inches)
Horizontal: 30 to 96 kHz
Vertical: 48 to 120 Hz
100 to 240 V, 50/60 Hz, Max. 1.7 A
130 W
Approx. 404 X 413.5 x 419.5 mm (w/h/
d) (16
X
16 ^/8
X
16 ^/8 inches)
Approx. 20 kg (44 lb 1 oz)
DDCl/DDC2B/DDC2Bi/GTF
See page 6
* Recommended horizontal and vertical timing condition
• Horizontal sync width should be more than 1.0 psec.
• Horizontal blanking width should be more than 3.0 psec.
• Vertical blanking width should be more than 500 psec.
Design and specifications are subject to change without notice.
If all four color bars appear (white, red, green, blue), the monitor
is working properly. Reconnect the video input cable and check
the condition of your computer.
If the color bars do not appear, there is a potential monitor failure.
Inform your authorized Sony dealer of the monitor’s condition.
If the (!) (power) indicator is flashing orange
Press the (!) (power) button twice to turn the monitor off
and then on.
If the (!) (power) indicator lights up green, the monitor is working
properly.
If the (!) (power) indicator is still flashing, there is a potential
monitor failure. Count the number of seconds between orange
flashes of the (!) (power) indicator and inform your authorized
Sony dealer of the monitor’s condition. Be sure to notejhe model
name and serial number of your monitor. Also note the make and
model of your computer and video board.
16