Adjusting the brightness and contrast, Adjusting the centering of the picture (center), Adjusting the size of the picture (size) – Sony CPD-G200 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
■ Using the control button
1 Display the main MENU.
Press the center of the control button to display the main
MENU on your screen.
Select the menu you want to adjust.
Highlight the desired menu by moving the control button
towards the rear to go up towards the front to go down
(■^), and left (•^) or right (^) to move sideways.
FRONT
REAR
3 Adjust the menu.
Move the control button left
{■ *
adjustment.
■) or right (^) to make the
4 Close the menu.
Press the center of the control button once to return to the
main MENU, and twice to return to normal viewing. If no
buttons are pressed, the menu closes automatically after about
30 seconds.
■ Resetting the adjustments
Press the RESET button. See page 12 for more information on
resetting the adjustments.
RESET
Adjusting the brightness and
contrast
Brightness and contrast adjustments are made using a separate
BRIGHTNESS/CONTRAST menu.
These settings are stored in memory for all input signals.
1 Move the control button In any direction.
The BRIGHTNESS/CONTRAST menu appears on the
screen.
□
0 2 6 0
2 6
0
2 Move the control button 'f/f to adjust the
brightness ( O:), and
to adjust the contrast
(
3
).
The menu automatically disappears after about 3 seconds.
Adjusting the centering of the
picture (CENTER)
This setting is stored in memory for the current input signal.
1 Press the center of the control button.
The main MENU appears on the screen.
2 Move the control button to highlight CENTER
and press the center of the control button again.
The SIZE/CENTER menu appears on the screen.
3 First move the control button 'f/f to select for
horizontal adjustment, or Q for vertical adjustment.
Then move the control button to adjust the
centering.
Adjusting the size of the picture
(SiZE)
This setting is stored in memory for the current input signal.
1 Press the center of the control button.
The main MENU appears on the screen.
2 Move the control button to highlight Q SIZE and
press the center of the control button again.
The SIZE/CENTER menu appears on the screen.
3 First move the control button ^/f to select Q for
horizontal adjustment, or d] for vertical
adjustment. Then move the control button to
adjust the size.