Sony CPD-G200 - Manual (Page 7)

step 3:Turn on the monitor and
computer
First turn on the monitor, then turn on the computer.
O
The installation of your monitor is complete.
If necessary, use the monitor’s controls to adjust the picture.
If no picture appears on your screen
• Check that the monitor is correctly connected to the computer.
• If NO INPUT SIGNAL appears on the screen, confirm that the
video signal cable is propierly connected and all plugs are firmly
seated in their sockets.
• If MONITOR IS IN POWER SAVE MODE appeared on the
screen, try pressing any key on the computer keyboard.
• If you are replacing an old monitor with this model and OUT
OF SCAN RANGE appears on the screen, recormect the old
monitor. Then adjust the computer’s graphic board so that the
horizontal frequency is between 30 - 96 kHz, and the vertical
frequency is between 48-120 Hz.
For more information about the on-screen messages, see “Trouble
symptoms and remedies” on page 14.
For customers using Windows 95/98
To maximize the potential of your monitor, install the new model
information file from the supplied Windows Monitor Information Disk
onto your PC.
This monitor complies with the “VESA DDC” Plug & Play standard. If
your PC/graphics board complies with DDC, select “Plug & Play Monitor
(VESA DDC)” or this monitor’s model name as the monitor type in the
“Control Panel” of Windows 95/98. If your PC/graphics board has
difficulty communicating with this monitor, load the Windows Monitor
Information Disk and select this monitor’s model name as the monitor
type.
For customers using Windows NT4.0
Monitor setup in Windows NT4.0 is different from Windows 95/98 and
does not involve the selection of monitor type. Refer to the Windows
NT4.0 instruction m^ual for further details on adjusting the resolution,
refresh rate, and number of colors.
Adjusting the monitor’s resoiution and coior number
Adjust the monitor’s resolution and color number by referring to your
computer’s instruction manual. The color number may vary according to
your computer or video board. The color palette setting and the actual
number of colors are as follows:
• High Color (16 bit)—► 65,536 colors
• True Color (24 bit) —► about 16.77 million colors
In true color mode (24 bit), speed may be slower.
Selecting the on-screen menu
language (LANG)
English, French, German, Spanish, Italian, Dutch, Swedish,
Russian and Japanese versions of the on-screen menus are
available. The default setting is English.
1 Press the center of the control button.
See page 9 for more information on using the control button.
MENU OK-«- Я
Г
COUDR
C3 j
CENTER
I ®
L conv
____
П
I GEOM EXIT
e
HELP
! ® I
L LANG
I Э
I
size J
I ®
OPTION
I___________________________
Move the control button to highlight @ LANG and
press the center of the control button again.
ENGLISH
F R A N Ç A I S
D E U T S C H
E S P A Ñ O L
I T A L I A N O
N E D E R L A N D S
S V E N S K A
Р У С С К И Й
Move the control button 4^/f to select a language.
ENGLISH
FRANÇAIS: French
DEUTSCH: German
ESPAÑOL: Spanish
ITALIANO: Italian
NEDERLANDS: Dutch
SVENSKA: Swedish
Р У С С К И Й : Russian
Q:$:g: Japanese
To close the menu
Press the center of the control button once to return to the main MENU,
and twice to return to normal viewing. If no buttons are pressed, the menu
closes automatically after about 30 seconds.
To reset to English
Press the RESET button while the LANGUAGE menu is displayed on the
screen.
7