Unpacking, Inserting batteries into the remote, 9 when to replace batteries – Sony STR-DB930 User Manual
Page 4: Notes, Before you get started, Hooking up the components
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hooking Up
the
Components
This chapter describes how to connect
various audio and video components
to the receiver. Be sure to read the
sections for the components you have
before you actually connect them to
the receiver.
Unpacking
Chock that you received the following items with the unit:
• FM wire antenna (1)
• AM loop antenna (1)
• Audio/video/control S connecting cord (1)
• CONTROL A1 connecting cord (1)
• FM antenna adapter (1)
STR-DB930 only
• Remote commander RM-LJ302 (remote) (1)
• LR6 (size-AA) alkaline batteries (3)
STR-DB830 only
• Remote commander RM-PP402 (remote) (1)
• R6 (size-AA) batteries (2)
Inserting batteries into the remote
Insert the LR6 (STR-DB930) or R6 (STR-DB830) (size-AA)
batteries with the + and - properly oriented in the battery
compartment. When using the remote, point it at the
remote sensor B on the receiver.
For details, refer to the operating instructions supplied
with your remote.
9 When to replace batteries
Under normal conditions, the batteries should last for about 3
months (STR-DB930 only) or 6 months (STR-DB830 only). When
the remote no longer operates the receiver, replace all batteries
with new ones.
Notes
• Do not leave the remote in an extremely hot or humid place.
• Do not use a new battery with an old one.
• Do not expose the remote sensor to direct sunlight or lighting
apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
• This remote is designed for use with alkaline batteries only. Do
not use a combination of different battery types (STR-DB930
only).
Before you get started
• Turn off the power to all components before making
any connections.
• Do not connect the AC power cords until all of the
connections are completed,
• Be sure to make connections firmly to avoid hum and
noise.
• When connecting an audio/video cord, be sure to
match the color-coded pins to the appropriate jacks on
the components: yellow (video) to yellow; white (left,
audio) to white; and red (right, audio) to red.