Sony STR-DB930 - Manual (Page 50)

Adjustments Using the SET UP Button
The SET UP button allows vou to make the tollowing
adjustments.
Adjusting the CONTROL A1 u auto
function
Turning on the CONTROL A1 II auto function parameter
lets you turn Sony components connected via CONTROL
A1 cords (see page 13) on automatically when you press
the corresponding function button.
Auto function is set to ON by default.
1
Press SET UP.
2
Press the cursor buttons (< or » to select "AUTO
FUNCTION."
3
Turn the jog dial to select "ON" or "OFF."
Setting up the 2 way remote
(STR-DB930 only)
This receiver is shipped from the factory with the 2 way
remote control system set to "ON." Normally, you can use
the receiver as is.
However, if you want to use this receiver together with
another compronent that is also compatible with the 2 way
remote control system, be sure to perform the following
operation to limit response to signals sent from the remote
controls.
To use with the TA-E9000ES
Perform the following steps to turn OFF this unit's 2 way
remote control system. Also, be sure the TA-E9000ES is
turned on when using this unit.
To use with other components that have the
logo
Turn OFF the other component's 2 way remote control
system. For details, refer to the operating instructions
suppled with your other components.
To use with Sony CD players CDP-CX260 or
CDP-CX88ES
Turn OFF the remote control adapter switch on the
CDP-CX260 or CDP-CX88ES. For details, refer to the
operating instructions suppled with the CDP-CX260 or
CDP-CX88ES.
Also when using several 2 way remote control system
components together, be sure to place them close together
in order to enable proper remote operation.
1
Press SET UP.
2
Press the cursor buttons « or »to select "2 WAY
REMOTE."
3
Turn the jog dial to select "ON" or "OFF."
50