Sony STR-DB930 - Manual (Page 44)

PRESET TUNING +/-
Direct Tuning
Brief descriptions of buttons used to
receive broadcasts
PRESET TUNING +/-: Press to scan all preset radio
stations.
TUNING +/-: Press to scan all available radio stations.
FUNCTION control: Rotate to select the tuner.
FM MODE: If "STEREO" flashes in fhe display and the
FM stereo reception is poor, press this button to improve
the sound. You will not be able to enjoy stereo effect but
the sound will be less distorted.
Note
If "STEREO" does not appear at all even when the FM broadcast
is received normally press this button to turn on the "STEREO"
indication.
FM/AM: Press to select the FM or AM band.
MEMORY: Uses for memorizing preset stations.
SHIFT: Press to select a memory page (A, B, or C) for
preseffing radio stations or tuning to preset stations.
Use the supplied remote to perform the following
operations.
For details on the buttons used in this section, see the
operating instructions for the supplied remote.
1
Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3
Press D. TUNING.
4
Press the numeric buttons to enter the frequency.
Example!: FM 102.50 MHz
® * ® * ( 2 ) * @ * @
Example 2: AM 1350 kHz
(You don't have to enter the last "0” when the tuning scale is
set to 10 kHz.)
If you cannot tune in a station and the
entered numbers flash
Make sure you've entered the right frequency. If not,
repeat Steps 3 and 4.
If the entered numbers still flash, fhe frequency is not
used in your area.
5 If you've tuned in an AM station, adjust the
direction of the AM ioop antenna for optimum
reception.
6 Repeat Steps 2 to 5 to receive another station.
ff If you try to enter a frequency that is too precise for the
tuning scale
The entered value is automatically rounded up or down.
Tuning scale is:
FM:
50 kHz
AM: 10 kHz (to change to 9 kHz, see page 54.)
44