Sony MZ-R50 - Manual (Page 16)

Setting the clock to
stamp the recorded
time
To stamp the date and time on the MD
vvheii you reaird, vou first need to set the
clock.
4
5
ITess ► to enter tl)e year.
Tlie digit of the month flashes.
Repeat steps 3 and 4 to enter the
current month, date, hour, and
minute.
When y(ui press ► to enter the
minute, the clock starts operating.
1 Connect the power source.
Use the supplied AC power adaptor.
2
Press CLOCK SET at the bottom of
the recorder.
Use a pointed object.
The digits of the year flash.
If you make a mistake while
setting the dock
Press ■, and set the clock again from step
2. You can skip a step by pressing
To display the current time
When the recorder is not operating or
while recording, press DISPLAY
repeatedly until the current time appears
in the display.
To display the time in the 24-
hour system
While setting the clock, press DISPLAY.
To display the time in the 12-hour system,
press DISPLAY again.
Charg/ng the buHt-in battery for the
clock
When you use the recorder for the first time
or after a long period of disuse, charge the
built-in battery. After setting the clock, leave
the recorder connected to the AC power for
atK^ut 2 hours to charge the built-in battery.
Once charged, the built-in battery should last
about a month without connecting to any of
the power sources. The recorder will
automatically charge the built-in battery while
connected to AC power, dry batteries or a
rechargeable battery.
Change the current year by pressing
or^W.
To change the digits rapidly, keep
pressing or