Sony MDS-JE520 - Manual (Page 25)

Playing MDs
Useful Tips When Recording
From IVIDs to Tape
MENU/NO
e j)
KM AMS »1]
Inserting blank spaces while recording to
tape (Auto Space)
The Auto Space Function inserts a 3-second blank
space between each track while recording from MDs to
tapes, allowing you to use the AMS function during
later playback.
1 While the deck is stopped, press MENU/NO
twice to display "Setup Menu".
2 Turn AMS to select "Setup 04", then press AMS.
3 Turn AMS to select "Auto Space", then press
AMS.
4 Press MENU / NO.
'Q* You can turn on the Auto Space Function using the
remote ®
While the deck is stopped, press A.SPACE repeatedly
until "Auto Space" appears in the display.
To cancel Auto Space
Cancelling the function through menu operation on the
deck
1 Do Steps 1 and 2 in "Inserting blank spaces while
recording to tape" on this page.
2 Turn AMS to select "Auto Off", then press AMS.
3 Press MENU/NO.
Cancelling the function using the remote [XI
while the deck is stopped, press A.SPACE repeatedly until
"Auto Off" appears.
Note
If the Auto Space Function is on while recording a selection
containing multiple track numbers, (for example, a medley
or symphony), blank spaces will be inserted within the
selection whenever the track number changes.
Pausing after each track (Auto Pause)
When the Auto Pause Function is on, the deck pauses
after playing each track. Auto Pause is convenient
when recording single tracks or multiple,
nonconsecutive tracks.
Select "Auto Pause" instead of "Auto Space” in Step 3
on "Inserting blank spaces while recording to tape" on
this page.
Q You can turn on the Auto Pause Function using the
remote
IX
While the deck is stopped, press A.SPACE repeatedly
until "Auto Pause" appears in the display
To restart playback
Press O or II.
To cancel Auto Pause
Cancelling the function through a menu operation on the
deck
Do Steps 1 to 3 in "To cancel Auto Space" on this page.
Cancelling the function using the remote
[X
while the deck is stopped, press A.SPACE repeatedly until
"Auto Off" appears.
Note
If you turn off the deck or disconnect the AC power cord, the
deck will recall the last setting of the Auto Space and Auto
Pause Functions the next time you turn on the deck.
Adjusting the analog signal level
You can adjust the level of an analog signal for output
to an amplifier connected through the LINE
(ANALOG) OUT jacks.
1 While the deck is stopped, press MENU / NO
twice to display "Setup Menu".
2 Turn AMS to select "Setup 13", then press AMS.
3 Turn AMS to adjust the analog output level.
4 Press AMS.
5 Press MENU/NO.
To return to the initial setting (O.OdB)
1 Repeat step 1 to step 2, then press CLEAR.
2 Press MENU/NO.
Notes
• The analog signal level for output to the headphones
connected through the PHONES jack is also changed.
• When you eject the MD or turn off the power by pressing
the l/Cl) switch, the output level is reset to the initial
setting (O.OdB).
25 "