To protect an md against accidental erasure – Sony MDS-JE520 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Basic Operations
When "TOC Writing" flashes in
the display
The deck is currently updating the
Table Of Contents (TOC). Do not
move the deck or pull out the AC
power cord. Changes to an MD
made through recording are saved
only when you update the TOC by
ejecting the MD or changing the
deck to standby by pressing the
1/(1) switch.
Press • REC.
The deck becomes reaciv to recorcf.
Press LEVEL/DISPLAY / CHAR to change the display, then
turn AMS to adjust the recording level.
For detaij^ see pages 12 and 13. If you want to know the
recording time or remaining time , press
LEVEL/DISPLAY/CHAR again.
8
Press O or
I I .
Recording starts.
Start playing the program source.
Do not disconnect the deck from the power source immediately after
recording
If you do, recorded material may not be saved to the MD. To save the
material, after recording, press » EJECT to take out the MD or change the
deck to standby by pressing 1/(1). "TOC Writing" will flash in the display at
this time.
After "TOC Writing" stops flashing and goes out, you can pull out the AC
power cord.
To
Press
Stop recording
■
Pause recording*
II. Press the button again or press t> to resume
recording.
Take out the MD
a EJECT after stopping
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.
I