Sony MDS-JE520 - Manual (Page 5)

Getting Started
Hookups
Connecting the deck to an amplifier
Connect the cnnpUtier to the LINE (ANALOC.) IN /
OUT jacks using the audio connecting cords (supplied),
making sure to match the color-coded cords to the
appropriate jacks on the components; red (right) to red
and white (left) to white. Be sure to make connections
tirmh' to prevent hum and noise.
MD deck Amplifier
Note
U Oin Unlock" alternates with "C7l", or "Cannot Copv"
appears in the display, recording through the digital
connector is nifl possible. In this case, record the program
source thri>ugh the LINE (ANALOG) IN jacks with the
INPUT switch set at ANALOG.
Connecting the AC power cord
Connect the AC power cord to a wall outlet or to the
outlet of a timer.
Signal flow
Connecting the deck to a digital component such as
a CD player, DAT deck, digital amplifier, or another
MD deck
Connect the component through the DIGITAL OPT 1 /
OPT 2 or DIGITAL OUT connectors with two or three
optical cables (only one supplied).
Take the caps off the connectors and then insert the
plugs parallelly until they click into place.
Be sure not to bend or tie together the optical cables.
If the optical cables are not connected properly, "Din
Unlock" and "C71" may alternate in the display.
MD deck Digital component
To the DIGITAL OPT 1
or OPT 2 connector
; Signal flow
Automatic conversion of digital sampling rates
during recording
A built-in sampling rate converter automatically
converts the sampling frequency of various digital
sources to the 44.1 kHz sampling rate of your MD deck.
This allows you to record sources such as 32- and 48-
kHz DAT or satellite broadcasts, as well as compact
discs and other MDs.