Canon DS-8 User Manual
Page 43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5
Insert the tip of the film leader into the film insertion guide. Be
careful to keep the film tightly wound on the reel.
6
Be sure that the pressure plate is at its proper position. If the
pressure plate is parted from the aperture section, the film can
not be advanced. Also check to see that the sprocket Guide and the
pressure plate tightening screws are not loose to secure the positive
film advance.
7
Depress the shutter release button while pushing the film leader
lightly into the film insertion guide. The film guide will close
and the film will automatically proceed through the film guides and
the aperture section and come out from the bottom sprocket. Stop
depressing the shutter release button when 15 to 20cm of film
leader has passed through the last guide roller.
8
Have the take-up spool ready. Bend the tip of the film leader
towards the emulsion side and insert into the take-up spool as
indicated by the diagram inside the camera. Wind the film leader
tightly three or four times around the spool.
Place the take-up spool on the take-up spool shaft.
9