Canon 3000 V - Manual (Page 15)

Loading and Unloading Film
Loading Film
After you load the film, the camera first winds the entire roll onto the
camera's take-up spool. With DX-coded film, the camera
automatically sets the film's ISO speed. Then each time a picture is
m
taken, one frame of film is rewound back into the film cartridge. The |
frame counter shows always number of shots remaining.
* •
I Turn the Mode Dial to any
setting except <QU9>.
^ Open the back cover.
• Slide down the back cover release
lever and open the back.
3 Insert the film cartridge at a
slight angle.
4 Align the film leader edge with
the <
A >
mark.
• Hold down the film cartridge while
pulling out the film leader. If you
pull out the film leader loo much,
rewind it back into the film
cartridge.
^ Close the back cover.
Close the back cover until it snaps
shut.
► Film prewind will start and there will
be a shutter-release sound about
10 sec. later. The < @ > icon and
frame count will also be displayed
on the LCD panel.
► During the film prewind, the ISO
speed will be displayed oh the LCD
panel.
15