Canon 3000 V - Manual (Page 47)

• Shutter
Type.......................................... Electronically conlrglted hjcal-ptane shutter
Shutter speeds.........................1/2000 - 30 sec. In 1^2'Stop ifKraibeite, bulb, X sync at 1/90 sec.
Shutter release.........................Soft touch electrumsgnetic release
Self-timer..................................Shoot after 10 sec. delay
Remote control .. .....................Remote Controller RC-1/RC-5 (DATE Model only)
• Flash
Built-in flash AF point-linked, 3-zone autoflash
Guide No. 12 (ISO 100, in meters), 39 (ISO 100, in feel)
Recycling time; Approx 2 sec.
Flash coverage: 26 mm lens angle covered
Red-eye reduction: Lamp
External EOS-dedicated flash ,„E-TTL / A-TTL / TTL autoflash
• Film transport
Film loading .............................Automatic prewind
Film advance modes.............. Single-frame/conlinuous shooting
Continuous shooting speeds...One Shot AF: Max. 1 5 fps
Al Servo AF: Max 1.3 fps
Film rewind........ ......................Automatic. Mid-roll rewind
• Date imprinting (DATE Model only)
Automalic dating,....................Automatic calendar to 2099
• Power source ........... _.*._Two CR2 lithium batteries
• Dimensions (W x Н x D) .130 x 88 x 64 mm/5.1 x 3 5 x 2.5 in
• Weight .................................. 340 g/12 0 oz (body only)
• All the specifications above are based on Canon’s testing and measuring standards
• Specifications and physical appearance are subject to change without notice.
TNs device compiles wilh Pari 1 5 of me FCC Rufoa. Opaffllion is sub|eci lo ihe following two
conditions: (1) This device may nol cause harmful IntET^&nce, and (2) this device must
accept any interference received, including interference lhal rray cause undesired operation
Do nol make any changes or modifications to the equipment unless otherwise specified in
the instructions If such changes or modifications should be made, you coukJ be required to
slop operation of the equipment
This equipment has been tested and found to comply with the limits lor a class B digital
device, pursuant lo pari 15 of the FCC Rules These limKs are designed to provide
reasonable protection against harmful interference in a residential installation This equipment
generates, uses and can radiate radio frequency energy and, H not installed and used in
accordance with the instructions, may cause harmful interference to radio communications
However, there is no guarantee that interference will not occur in a particular installation If
this equipment does cause harmful interference lo radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged lo try lo correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between Ihe equipment arKf receiver.
• Consult the dealer or an experienced radio/TV technician for help
This digital apparatus does nol nxceed Itis Ctisa B timila for radio noise emissions Irorr
digital apparatus as set out in the interference-causing equipment standard entitled “Digital
Apparatus”, ICES-003 of the Industry Canada
C€
The CE Mark is a Directive conformKy mark of the European Community (EC)
J
47