Making the connections, Back panel – AVer SPC300+ User Manual
Page 9
E-3
English
繁體中文
日本語
ภา
ษาไ
ท
ย
M
M
a
a
k
k
i
i
n
n
g
g
t
t
h
h
e
e
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
o
o
n
n
s
s
The ports at the back and right panel of the SPC300 enable you to connect the unit to a
computer, graphics display monitor, LCD/DLP projector, TV or other devices. Illustrated
below are the ports located at the back and right panel of the SPC300 with their
corresponding labels.
Back Panel
(1) (2)
(6) (7)
(5)
(4)
(3)
Name
Function
(1) DC 12V port
: Connect the power adapter into this port.
(2) RGB output port
: Output RGB signal from camera, RGB input port,
or the captured images from the memory source
and preview it on a VGA/Mac monitor or LCD/DLP
projector.
(3) S-Video output port
: Output the signal from the camera or the captured
images from the memory source on TV or AV
equipment.
Connecting the S-Video/RS-232 cable allows
using a computer to control SPC300 thru RS-232
connection.
(4) Video output port
(RCA/Composite)
:
Output the signal from the camera or the captured
images from the memory source on TV or AV
equipment.
(5) DVI-I output port
: Output RGB signal from camera, RGB input port,
or the captured images from the memory source
and preview it on a LCD/Mac monitor or LCD/DLP
projector with DVI-I interface.
If the display device does not support DVI-I, it can
only display RGB signal from camera and preview
captured images.
(6) USB port
: Use SPC300 as a USB Camera or Mass Storage
device allowing you to transfer the captured
images to and from the SPC300 memory source
and PC.
(7) SD card slot
: Insert the SD card with the label facing up. This
supports 16~512MB card capacity and only
accepts FAT16 formatted card.