Cleveland Range (T) MKDL-125-T (-CC) - Manual (Page 11)

Tilting Kettle
1. Raise MIXER BRIDGE and
swing to side.
2. For manual tilt: turn
HANDWHEEL.
3. For power tilt: turn switch
" " to raise, or " " to tilt.
WARNING- Do not tilt kettle
when mixer agitators are in kettle
bowl.
Mixing
1. Turn MIX/LIFT SWITCH to "MIX".
2. Turn MIXER SPEED
CONTROL to "MIN" and
slowly adjust to desired
speed.
3. Adjust SECONDARY SPEED
CONTROL to desired speed.
MIX LIFT
OFF
UP DOWN
OFF
Lifting & Lowering
Bridge
WARNING- Insure FAUCET
SPOUT is out of way before
raising or lowering bridge.
1. Turn MIX/LIFT SWITCH to "LIFT".
2. Turn MIXER SPEED
CONTROL to "MIN" and back
up to #5.
3. Turn and hold UP/DOWN
SWITCH "UP" to raise or
"DOWN" to lower.
MIX LIFT
OFF
General Operation
1. Turn MAIN POWER SWITCH
to "ON".
OFF ON
Operating Suggestions
Cleveland Range Mixer Kettles are simple and
safe to operate. The following tips will allow you to
maximize the use of your new mixer.
1. To achieve optimum performance on tilting
kettles;
Before applying steam to a cold kettle, open
the DRAIN COCK to drain condensate from the
kettles jacket. Close drain cock when unit is
fully drained.
2. Allow unit to preheat before addition of product to
kettle. However when cooking egg and milk
products, the kettle should NOT be preheated, as
products of this nature adhere to hot cooking
surfaces. These types of foods should be placed
in the kettle before heating is begun.
3. An important part of kettle cleaning is to
prevent foods from drying on. For this reason,
cleaning should be completed immediately
after cooked foods are removed. Refer to the
"Care and Cleaning" instructions for detailed
kettle washing procedures.
4. If a mixer bridge is equipped with a
temperature probe for a controller or
thermometer, the probe must be submerged a
minimum of three inches in the product for
accurate readings.
Safety
1. Close PRODUCT DISCHARGE VALVE before
filling the kettle.
2. When raising or lowering MIXER BRIDGE,
insure FAUCET SPOUT is not in the way of
MAIN AGITATOR ARM or damage to spout
will result.
3. As a safety precaution the MIXER SPEED
CONTROL must first be turned to zero before
unit will start to mix.
4. Always remember, like a cooking pot the
kettles become very hot when cooking. Avoid
contact with bare skin.