AVer EB3004_MD User Manual
Page 35
31
OSD MENU
Description
EVENT SETUP
ALARM SETTING
SENSOR SETTING
MOTION DETECTION
ALARM SETTING
Configure parameters of alarm.
ALARM CONTINUOUSLY
ALARM PERIOD
ALARM TYPE
SELECT / DESELECT ALL
SENSOR
RECORD
MOTION DETECTION
VIDEO LOSS
HDD FAIL
005 SEC
ALARM SETUP
1
2
3
4
ALARM TYPE
Select the way of alarming – RECORD or RELAY.
ALARM CONTINUOUSLY
Enable/disable to execute the alarm action (ALARM TYPE)
continuously when alarm has been trigger. The alarm action is
according to the setting of ALARM TYPE that user has setup.
i
- When
ALARM CONTINUOUSLY has been started, it
won’t be stop until the recording has been stop
manually.
- If
ALARM CONTINUOUSLY has been enabled, the
ALARM PERIOD won’t be able to configure.
ALARM PERIOD
Set the amount of time (in seconds; 0~ 999) for stop alarm
action after alarm has been reset.
i
If ALARM CONTINUOUSLY has been enabled, the
ALARM PERIOD won’t be able to configure.
SELECT/DESECLECT ALL
To enable/disable all below selections.
SENSOR
Enable/disable to send out the alarm when sensor has been
triggered.
MOTION DETECTION
Enable/disable to send out the alarm when motion has been
detected.
i
To activate the motion recording, please enable the
Motion Detection feature here and setup record mode
as ALARM RECORD in
RECORD SCHEDULE
.
VIDEO LOSS
Select the channel that will send out the alarm when video is
lost.
HDD FAIL
Enable/disable to send out alarm when hard disk is failed.