7 error codes – Salter Brecknell SBI100 User Manual
Page 31
SBI 100 User Instructions Manual
29
7 Error Codes
Error Message
Definition
Required Solution/Troubleshooting
0¯ ¯ ¯ ¯:
Weight above range for calibrated
zero point.
Remove load before zeroing Or Recalibrate the scale.
0_____:
Weight below range for calibrated
zero point.
Remove load before zeroing Or Recalibrate the scale.
_____:
Indicates an under range condition
Remove all loads and zero the scale.
¯ ¯ ¯ ¯:
Capacity exceeded
Remove the load and try again. If the load is great than 6 kg a scale
with a larger capacity is required.
CAL-Er:
Calibration error
Restart calibration
Lo.bAt:
Low Battery
Recharge the battery. Upon initial use, it is recommended to charge
battery for 8 hours prior to use.
EEP.E0
EEPROM can't be accessed
Replace S100 Indicator
EEP.E1
Configuration settings have changed
and not been stored
Calibrate the scale to store settings
EEP.E2
P7-P9 settings exceed scale's normal
range
Reconfigure P7-P9 setting