CASO Germany VC 12 Vacuum Set - Manual (Page 44)

caso Vakuumierer VC12 44
Please open the adapter and clean it with warm
water.
Opened adapter
Wipe off the adapter with a soft cloth and put it
together again afterwards.
16 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
16.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
16.2 Cause and Action
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error Possible cause Rectification
Vacuum unit is not
functioning
Power plug is not plugged
in
► Plug in mains plug!
Defective power cable or
plug
► Send device to Customer
Service
Defective electrical socket
► Select another electrical socket
The first weld on the cut
off piece of the roll is not
being carried out.
Roll is not positioned
correctly
► Follow the steps in the chapter
“Vacuum packaging in a bag
originating on the roll”
A complete vacuum is
not being created in the
bag.
The open end of the bag is
not completely inside the
vacuum chamber
► Position the bag correctly
The bag is defective
► Select another bag
There is dirt on the
welding and the normal
seals
► Clean the seals and retry
correctly once they are dry
The bag is not being
welded correctly The welding bar is
overheating so that the bag
melts
► Open the cover on the unit and
let it cool down for a few
minutes