Detex Exit Switch - Weatherized - Manual (Page 2)

1. Siren will beep and red LED will blink at approximately 45 second intervals when battery is low
2. While holding Pushpad depressed, turn key clockwise (CW). Pushpad should remain depressed
1. When the unit is in full alarm and the bar is released, the alarm will shut off after 2 minutes.
The Detex Advantex devices are designed to provide many years of maintenance
free service under normal usage. Periodically inspect and lubricate the unit to extend its life.
(Key is removable after rotating back to horizontal position)
2. If the unit is armed, the red LED will blink every 15 seconds.
3. If the unit is disarmed, the green LED will blink every 15 seconds.
3. Depress Pushpad (Siren will sound and red LED will illuminate)
R
Care and Maintenance:
LOW BATTERY ALERT:
3. Unit is now disarmed.
DOGGING FEATURE: (non-fire rated units only)
4. Turn key clockwise (CW). Turns alarm off.
Disable AUTO REARM (Off)
1. Slide the switch to ON and apply power.
1. Depress Pushpad
STATUS INDICATOR
Refer to tables 1, 2 & 3 on page 3
"EA" ALARM OPERATIONS
Note: Unit is shipped with Disable Auto Rearm turned ON and Status Indicator turned OFF
1. When operating the ON/OFF switch, there is a slight delay.
2. The key is inserted and removed only in the horizontal position (home position).
3. Key function: counter clockwise (CCW) = Armed; clockwise (CW) = Disarmed
1. Turn key counterclockwise (CCW) (key is removable after rotating back to horizontal position)
2. Red LED will flash twice, then green LED will illuminate for the 15 second delay time, then turn off.
The siren will sound three short beeps indicating the unit is armed.
4. The power needs to be removed to register changes in the slide switches.
SPECIAL NOTES and DEFINITIONS
b. Disable Auto Rearm
a. Status Indicator (This will affect battery life)
c. Dis Lo Bat INDicator
UNIT ARMING TEST:
Green LED
(LHR shown)
Red LED
Siren
PushPad
Mortise cylinder
Figure 1. Device features.
104873 Page 2