Dynojet 224x: Installation Guide - Manual (Page 16)

Above Ground Model 224 Automotive Dynamometer Installation Guide
C H A P T E R 1
Dynamometer Specifications and Requirements
1-6
Figure 1-1: Model 224 Dimensions
C OMPRESSED A IR
The following requirements are needed for the air brake:
• Clean and dry air, between 100-140 psi
• shut off valve
• 1/4-inch NPT pipe thread connector (to attach air to the dyno), if air hose does not
have a 3/8-inch inside diameter
C OMPUTER S PECIFICATIONS
You will need to provide a computer system to run the WinPEP software. A complete
list of system requirements can be found in your WinPEP 7 User Guide. This manual is
included with your dyno and is also available on your WinPEP 7 CD.