Dynojet 224x: Installation Guide - Manual (Page 30)

Above Ground Model 224 Automotive Dynamometer Installation Guide
C H A P T E R 2
Dyno Installation
2-10
A NCHORING THE D YNO
Dynojet recommends you secure your dyno to the floor in your dyno room using
concrete anchors.
You will need the following parts:
• 36923100 Washer, 3/8", Hardened, Flat, Steel (4)
• 37513200 Anchor, Redhead, 3/8" (4)
• 37518200 Redhead Anchor Installation Tool
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (4)
1 Using the mounting feet as a template, mark and drill each hole needed to secure
the four dyno feet to the floor.
2 Remove the 3/8 x 1-inch bolt and 5/16-inch flat washer securing each mounting
foot to the dyno and set aside.
3 Remove each mounting foot and set aside.
4 Install four Red Head anchors. Refer to Appendix A for installation instructions.
5 Secure each mounting foot to the dyno using the bolts and flat washers removed
earlier.
6 Secure each mounting foot to the floor using one 3/8-16 x 1-inch hex bolt and one
3/8-inch flat washer.
Figure 2-7: Secure the Dyno to the Floor
I NSTALLING THE E DDY C URRENT B RAKE
Refer to the Eddy Current Brake Installation and User Guide for Model 224 Above
Ground Automotive Dynamometers (P/N 98215100) for eddy current brake
installation instructions and install your eddy current brake at this time.
AD216
secure dyno
to floor
secure dyno
to floor
lift