Dynojet 224x: Installation Guide - Manual (Page 55)

B A S I C D Y N O O P E R A T I O N
Preventative Maintenance
Version 4 Above Ground Model 224 Automotive Dynamometer Installation Guide
3-13
V ERIFYING THE SAAR B RAKE P RESSURE
1 Verify the SAAR brake pressure gauge reads 100psi (690kPa).
2 Using the knob, adjust the regulator until the correct pressure is achieved.
Figure 3-6: Check the SAAR Brake Pressure and Adjust the Regulator
AB096
use knob to adjust
regulator until correct
pressure is achieved
brake pressure
regulator
0
AB095
brake pressure gauge
should read 100psi
(690kPA)