Dynojet 224x: Installation Guide - Manual (Page 64)

Above Ground Model 224 Automotive Dynamometer Installation Guide
A P P E N D I X B
Early Style Deck Installation
B-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EARLY STYLE DECK INSTALLATION
Before installing the deck, be sure you have routed any cables and connected your
shop air.
If you did not order the Above Ground Kit you will not have a deck.
1
Install the rear deck mounting brackets using two 3/8-16 x 1-inch bolts and two
washers.
Note: If you have an eddy current brake you will only install one mounting
bracket.
2 Loosely attach the two outside braces to the dyno using two 3/8 x 1-inch bolts and
two 3/8 x 1-inch nylock nuts.
3 Loosely attach the two inside braces to the dyno using two 3/8 x 1-inch bolts and
two 3/8-inch lock washers.
Note: Leave bolts loose.
Figure B-1: Deck Brace Installation
outside
deck brace
nuts
bolt
outside
deck brace
lock washer
bolt
bolt
inside
deck brace
mounting
bracket