Dynojet 248x: Installation Guide - Manual (Page 24)

3 - 6 Document #98219101
Mount the brakes on the dyno frame. Use
three bolts, three nuts, and three lock
washers on each brake weldment.
- Remove the nuts and lock washers from
the dyno frame leaving the bolts in place.
- Place the brake weldments over the bolts
on the frame.
- Finish the installation of the brake
weldments with the nuts and lock washers.
Step 4
Install the air hose between the brakes, using
the ports on the sides of the air canisters.