Dynojet 248x: Installation Guide - Manual (Page 35)

Document #98219101 3 - 17
The line labeled "IN" is connected to the
brass cross. Push the hose in then hand
tighten the fitting. Pull on the hose to
ensure it is seated properly. If it moves,
tighten the fitting more.
Standard Air Step 3
(Go on to step 4)
Proportional Air Step 3
Install the Temperature Sensor on the left
rear panel.
Loosely install the left side back cover over
the brake so the Dynojet stickers face out
and upright. (Use the self tapping screws
provided.)
Measure down 24" from the top of the dyno
and mark the left dyno support tube.