Dynojet 248x: Installation Guide - Manual (Page 39)

Document #98219101 3 - 21
Proportional Air Step 4
Complete the breakout board wiring as in the
following descriptions:
(A) Data acquisition cable coming from the optical
pickup on the dyno shown on the left.
These four wires go to the section of the card
Labeled “DRUM”:
The red wire connects to R1.
The white wire connects to W1.
The black wire connects to B1.
The silver wire connects to S1.
(B) One yellow and one black wire go to the two
connections Labeled “PRESS”. They connect to
the air sensor (shown on the left) located on the
Booster Valve Assembly. They can connect
in either order.
C B
A
D
E