Dynojet 248x: Installation Guide - Manual (Page 31)

Document #98219101 3 - 13
Step 5
To adjust the side catwalks so they are level,
the support arms can be turned while on the
pegs and the screw will raise or lower the
side catwalks.
Step 6
Place the railing posts in the pockets and
secure them with the 1/4“ bolts and nuts.
Step 7
String the chain through the holes (using the
end with the bolt) in the top of the railing post.
The chain should start on one end of the side
catwalks, pass through all the posts and
terminate on the opposite side catwalk. Place
the end-cap over the bolt on the end of the
chain and tighten it until the bolt comes to the
end of the end-cap.