Dynojet 248x: Installation Guide - Manual (Page 7)

Document #98219101 1 - 3
DynoWare EX+ Placement
The DynoWare EX+ system is comprised of
four modules: the CPU module, the
Dynamometer Input/Output module, the
RPM module and the Atmospheric module.
The Dynamometer Input/Output module
connects to the dynamometer. (A 20 foot
(6.1 meter) long cable is provided.) The CPU
module connects to a personal computer. (A
12 foot (3.7 meter) long cable is provided.)
RPM Pickups and a Hand Held Pendant also
connect to the modules. These modules
need to be located where they will be visible
during a dyno run. It is recommended that
they be mounted on a shelf on the wall or on
a cart along side the PC. An optional
extended Hand Held Pendant cable is
available if needed.