Dynojet 424x: Installation Guide - Manual (Page 32)

In Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
C H A P T E R 2
Unpacking and Inspecting the Dyno
2-8
4 Remove the crate braces that support the top portion of the crate.
5 Remove the four lag bolts and washers securing the dyno to the crate base.
6 Remove the five screws securing the front and rear drum guards and set aside.
7 Remove the front and rear drum guards and set aside.
8 Remove the two screws securing the left and right drum guards and set aside.
9 Remove the left and right drum guards and set aside.
# RECORD
Be sure you record the dynamometer number on the inside cover of this
manual.
Figure 2-1: Remove the Drum Guards
AD134
front/rear drum guard
dyno number
left/right drum guard