Dynojet 424x: Installation Guide - Manual (Page 99)

E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Pit Covers
Version 7 In Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
4-15
13 Once you have calibrated the load cell, install the pit calibration covers using six
1/4-20 x 5/8-inch torx screws each.
Note: Do not install these covers until you have finished calibrating the load cell.
Refer to page 4-20 for calibration instructions.
Figure 4-16: Install the Calibration Covers
AD448
calibration cover