Dynojet 424x: Installation Guide - Manual (Page 44)

In Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
C H A P T E R 3
Track Assembly
3-8
4 Loosely install the ten rail tie clips using one 3/8-16 x 1.5-inch flange-head bolt
per clip. There are five rail tie clips on each side of the track assembly.
5 Verify the track assembly is square and make any necessary adjustments.
6 Tighten all ten bolts.
Note: For clarity, the pit and stationary dyno are not shown.
Figure 3-4: Install the Rail Tie Clips
AD103
bolt
rail tie clip
rail
anchor in floor
rail tie