Dynojet 424x: Installation Guide - Manual (Page 80)

In Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
C H A P T E R 3
Bridge Installation—4WD Dyno
3-44
I NSTALLING THE B RIDGE C OVER AND R UNNER T IE S TRAPS
1 Secure the cover to the runner mounts using the two reserved 3/8 x 1.5-inch
flange hex allen bolts from earlier.
2 Secure the cover to the runner assemblies using two 1/4 x 5/8-inch torx head
bolts.
3 Secure one runner tie strap and one plastic runner tie slide to each set of
moveable runner assemblies using six 1/4 x 5/8-inch torx head bolts each.
Figure 3-31: Install the Cover and Runner Tie Straps
AD387
1/4 x 5/8-inch torx
head bolt
cover
3/8 x 1.5-inch flange
hex allen bolt
runner tie slide
runner tie strap