EFCO 525 Series - Manual (Page 21)

[FIG. 19]
SECTION VI - DOOR FRAME INSTALLATION
[FIG. 20]
[FIG. 18]
PAGE 19
(CONT.)
4478
4487
4484
SHOWN
4483
SIMILAR
4487
4488
4488
4486
STEP 8) TRANSOM GLASS STOP INSTALLATION
When the glass is installed, the door header glass stop should be installed
first. Once this is accomplished, the removable transom glazing stops can
be installed. The transom glass stops should run from the bottom of the
transom head to the top of the door header. The transom glazing stops
do not snap onto the applied transom stops, but rather hook on and are
held in place by the exterior glazing gasket pressure. The exterior glazing
gasket and the interior glazing seal are installed in the same manner as
shown in figures 71-73 on pages 41 and 42. See figures 18-20 below for
header glass stop and transom glass stop installation.
525 IMPACT DPS 1/2004