ETS-Lindgren HI-6113 Laser Data Interface and Probe Measurement System - Manual (Page 30)

30 | ProbeView Laser Software
Probe Menu Description
Units Sets the units of measure in which data will be
viewed and collected. The available units are
probe-dependent.
Plot Total Field
Strength
Disables plotting of the total field strength. Only
the orthogonal values are plotted.
Clear Peak Clears the peak values. The peak values are
automatically cleared at the start of a new log
session. The user is not allowed to clear the
peak values manually during logging.
Update
Battery/Temperature
Causes the probe to immediately update current
battery status and temperature information.
Auto Update Interval Updates the battery status and temperature at
the selected interval: Off, 5 minutes,
30 minutes, or 60 minutes. Battery status and
temperature are not updated during logging.
Temperature Units Fahrenheit or Celsius
Alarm Enable Enables an audio alarm to indicate a preset field
level has been exceeded.
Set Alarm Value Sets the value that will trigger the audio alarm.