ETS-Lindgren HI-6113 Laser Data Interface and Probe Measurement System - Manual (Page 34)

34 | ProbeView Laser Software
U NITS
The units of field strength or power density available for the attached probe.
Clicking on the Units label scrolls through the available units.
The units cannot be changed while logging.
T EMPERATURE
The temperature returned from the Field Probe. Units may be switched between
Fahrenheit and Celsius using the menu. The temperature may be updated by
clicking the Prb Tem label.
P ROBE I NFORMATION
The probe type is displayed in the lower left status bar. Additional information
may be available by selecting the Help menu.
P EAK
Shows the maximum field value since the last time the value was cleared. To
clear this value, click on the Peak label or the Bar Graph. The peak values will be
automatically reset at the start of logging. The peak field values cannot be
cleared manually during data logging.
B AR G RAPH
Displays the data for the probe that is currently in use.
Bar Graph Display Definition
Field The combined X, Y, and Z values.
X-Data Value displayed by X-Value.